Hand pulling a sheet of paper from a refrigerator door seal to test it

5 Signs Your Refrigerator Door Seal Is Failing (and When to Replace It)

Refrigerator & Freezer Repair

A refrigerator door seal, also called a gasket, is the flexible strip around the door that keeps cold air in. When it wears out, warm air leaks in, the compressor runs longer, frost builds up, and your energy bill can creep up. The good news is that a failing seal is easy to test, and replacing one is usually far cheaper than replacing the refrigerator.

Key Takeaways

  • Signs include visible tears or hardening, frost or condensation around the door, a refrigerator that runs constantly, and food that spoils faster.
  • A simple paper test, with a dollar bill or sheet of paper closed in the door, shows whether the gasket grips evenly all the way around.
  • Dirty gaskets can sometimes be fixed with cleaning, but torn, hardened or flattened ones need replacement.
  • Some seals snap into a channel and are easy to swap, while others are built into the door and are better left to a technician.
  • Door alignment, leveling and overfilled shelves can mimic a bad seal, so check those too.

5 Signs Your Door Seal Is Failing

1. Visible damage

Look for cracks, tears, splits, hardened or flattened sections, strips pulling away from the door, and mold along the folds.

2. Frost, ice or condensation around the door

Warm, moist air leaking past a bad seal condenses and freezes, often around the door edges or on the inside near the door.

3. The refrigerator runs almost constantly

When cold air escapes, the compressor works harder to keep up, which can also show up as a higher energy bill.

4. Food spoils faster or temperatures swing

Leaking cold air makes it hard to hold a steady temperature, so food can spoil sooner and the freezer may frost over.

5. The paper test fails

The test below catches leaks you cannot see, which is why it is the most reliable check.

How to Do the Paper Test

💵The Dollar Bill Test

1

Close the paper in the door. Shut a dollar bill or a sheet of paper in the door so it is half in and half out.

2

Try to pull it out. You should feel resistance. If it slides out with no drag, the seal is not gripping there.

3

Test all the way around. Check both top corners, the sides, the bottom corners and across the bottom. The lower hinge corner and the bottom edge are common failure points.

4

Test the freezer door too. Many refrigerators have separate seals on each door.

A seal that grips in some spots and fails in others usually means the gasket is worn or the door is misaligned.

Clean, Adjust or Replace?

SituationLikely fix
Gasket is dirty or stickyClean with warm, soapy water, dry it, and test again
Refrigerator is not level or the door sagsLevel the refrigerator and check the hinges and door alignment
Overfilled shelves keep the door from closing fullyRearrange so the door closes all the way
Gasket is torn, hardened, flattened or pulling awayReplace the gasket
Gasket looks fine but the door still will not sealHave a technician check the door and frame

Always use the gasket made for your exact model number. Cost varies by brand and model, so ask for an itemized estimate.

On many models the gasket pulls out of a groove and a new one presses in. On others it is held by screws behind a retaining strip or built into the door panel. Built-in and high-end units can be more involved, and a damaged door liner is best handled by a technician. A new gasket can take some time to settle, so retest after a day.

When to Call a Technician

  • A new seal still leaks, or the door will not close properly.
  • Frost or condensation keeps coming back.
  • The seal is built into the door or the unit is a built-in or professional-style model.
  • You are not sure whether the seal, the door or the cooling system is the problem.

The symptoms of a bad seal overlap with other problems, such as an overcooled compartment. If food is freezing instead of leaking, see why a refrigerator freezes food. For an older unit, our repair-or-replace guide helps you weigh the cost.

Not sure if it is the seal or something else?

Get a Quote

How Complete Repair LLC Helps Black Diamond Homeowners

We diagnose and repair refrigerators across Black Diamond and the greater Seattle Metro Area. See our refrigerator repair service or request a quote.

Frequently Asked Questions

How long does a refrigerator door gasket last?

There is no fixed lifespan. Wear depends on age, use and how well the gasket is kept clean. Replace it when it is torn, hardened, flattened or fails the paper test.

Can I fix a torn door seal with tape or glue?

Temporary fixes rarely restore a proper seal, so replacement is usually the dependable fix.

Does a bad door seal raise my energy bill?

It can. When warm air leaks in, the compressor runs more to keep up, which uses more electricity.

How do I tell if it is the seal or the thermostat?

Do the paper test and look for visible damage first. A seal problem usually shows up as frost or condensation near the door, while a control problem tends to affect the whole compartment.

Can I replace a refrigerator door seal myself?

On many models, yes, using the part made for your exact model. If the gasket is built into the door or the unit is a built-in model, a technician is the better choice.

CR

Written and reviewed by Complete Repair LLC. Our certified technicians serve Black Diamond and the greater Seattle Metro Area, with transparent upfront pricing and documented estimates on every visit.

Door seal not sealing?

Complete Repair LLC can check the seal and the cooling system and give you a clear estimate. We serve Black Diamond and the greater Seattle Metro Area.

Get a Quote